Abs System - VOGE DS900X Operation Manual

ABS system

1.Deceleration and braking under normal situation, release the throttle first, tightly hold the han dle bar and then brake. When
driving speed fell, to avoid engine stop working, hold clutch lever to get into low gear position.
2.Decelerate before turning, when passing the turning, do everything possible to keep an even speed, in case it is needed, slightly
brake, the sudden braking is forbidden.
3.Decelerate in advance in case met the wet road even water on road, take care.
4.Judge the road condition in advance to avoid sudden braking.
5.When the emergency was met, swiftly release the throttle and tightly hold the handle bar and brake by full power.
1.For the models with function ABS, when braking in full power, there will be obvious bounce back on brake lever or pedal with
frequency, which is normal, don't worry about it, only need to do is tightly hold the grips for handle bar.
2.How the ABS works and operates
(1). When ABS/TCS got on: When motorcycle is power on, the self-inspection haven't finished: The AB S can inspect
malfunction for wheel speed signal, but it needn't get power source on once again, when the signal for wheel speed recovered,
the malfunction could be erased and get back to normal situation; When self-inspection finished: Th e ABS can take signal
malfunction of wheel speed into record, under this case, the motorcycle power source needs be start ed once again, which
means even wheel speed recovered, the motorcycle needs be got power on once again, then the malfunc tion could be erased
and recover to normal situation.
(2). When ABS/TCS is off: Get motorcycle power on, the self-inspection haven't finished: The ABS can take signal malfunction
of wheel speed into record, when the wheel signal recovered, the malfunction could be erased and re cover to normal situation,
when power source of motorcycle needn't be got on once again; When self-inspection finished: The ABS can take malfunction
of wheel speed into record, the power supply of motorcycle must be restarted, even wheel speed sign al recovered, the power
supply of motorcycle still needs be restarted, then the malfunction could be erased and recover to normal situation.
No matter ABS/TCS were on or off, once there is malfunction for wheel speed, it alarms (The indicator light for ABS/TCS gets
on)
In case decelerate from high speed, use the front or rear brake only is dangerous, the motorcycle is easy to skid or get out of
control, please use the front and rear brake in a balancing way.
The driving mode shifted to Enduro (Cross country), the ABS will then get off.
!
Caution
!
Danger
42