Compound Selection; Cleaning; Water Tank; 10. Maintenance - GARANT GMT35 Instruction Handbook Manual

8.3.

COMPOUND SELECTION

Settings
UNI
COPPER
New Compound
4
1 Select pre-installed compounds
2 Edit compound
9.

Cleaning

9.1.

WATER TANK

Protective gloves and safety glasses
CAUTION
Chemicals
Acid burns and heat burns of the skin, eyes, hands or feet.
» Wear safety glasses and protective gloves.
» Dispose of the compounds in accordance with the local regulations.
» Comply with the safety data sheet from the respective compound.
1. Open both the doors for access to the water tank.
2. Pull out the water tank.
3. Place the container under the outlet valves and open the outlet valves.
4. Clean the water tank and dispose of the chemicals in accordance with the national and regional regulations.
5. Alternatively use the wet and dry vacuum cleaner (Article no. 078541 751-11) to suck the contents from the entire water
tank.
6. Take out the filter, wash it and reinstall it.
7. Push the water tank into the surface finishing machine and lock the doors.

10. Maintenance

 It is mandatory to comply with the maintenance intervals.
DANGER
Electrically live components
Risk of fatal electric shock.
» Before starting any maintenance work switch the unit off and disconnect it from the power supply, release it and pro-
tect it from being switched on again.
» Check that the system is electrically dead, earth it and short circuit it.
» Insulate any adjacent electrically live components.
» Maintenance and repair may be performed only by electrical specialists.
» If any live components suffer damage, have them repaired immediately.
Interval
Every 20 operating hours
SHINY
ALUMINIUM
PLASTIC
3 2
Maintenance work
Clean abrasive chips and particles from
the water drain inserts in the trough.
1
3 Delete selected compound
4 Add compound
Performed by
Trained specialist for mechanical work
www.hoffmann-group.com
de
en
cs
da
es
fr
hr
hu
it
nl
pl
ro
sl
53