Operation; Exchanging The Sieve; Preparative Work - GARANT GMT35 Instruction Handbook Manual

7.

Operation

DANGER
Damaged or non-operational safety devices
Risk of fatal accident or serious injuries.
» Do not use the unit with damaged, non-operational or bypassed safety devices.
» Before using the unit, check the safety devices for correct operation.
» Before using the unit, check it for obvious damage.
» If it is damaged, switch it off immediately, secure it against being switched back on inadvertently, and inform the re-
sponsible office.
CAUTION
Strong vibrations
Crush hazard for the body and individual limbs due to the surface finishing machine unintentionally rolling away.
» Apply the parking brakes before starting the surface finishing machine.
7.1.

EXCHANGING THE SIEVE

B
i
Select the appropriate sieve for the size of workpiece and size of abrasive chips.
1. Undo the lock nut and screws, pull the sieve out.
2. Push the new sieve in as far as the stop.
» The abrasive chips must be able to fall through the grid.
3. Tighten the four screws and lock nuts.
7.2.

PREPARATIVE WORK

E
ü Using the parking brakes to lock the castors.
ü Main switch set to "ON".
ü Cover at the outlet from the trough on the separation unit closed.
1. Unlock the door for access to the water tank.
2. Using a measuring beaker, measure out the required quantity of compound and pour it into the left unit of the water
tank.
3. Pour approx 45 litres clean water into the left unit of the water tank.
» The compound will mix with the water that was poured in.
4. Push the water tank into the surface finishing machine and lock the door.
5. The following modifications to the trough may be performed to suit the characteristics, quantity and size of the work-
pieces:
Trough modification
Full trough without dividing wall
Left-hand chamber of the trough, partitioned off by a plastic
dividing wall
Left-hand chamber of the trough, partitioned off by an alu-
minium dividing wall
1. Depending on the application, select appropriate abrasive chips and fill the left hand chamber or the entire trough.
Maintain a maximum filling level 3 cm below the water outlet.
2. Use the setting on the screen to check the water delivery (pump ON/OFF).
Trained specialist for mechanical work.
Hearing protection, safety glasses, protective gloves, safety shoes
Workpiece characteristic
Large workpieces which require the full extent of the trough
so they can be processed without tilting.
High-gloss workpieces and delicate workpieces. If the plastic
dividing wall is being used, both chambers of the troughs
must be filled with abrasive chips.
Small workpieces which can be processed without tilting in a
single chamber. If an aluminium dividing wall is used, fill
either the left-hand chamber or both chambers.
www.hoffmann-group.com
de
en
cs
da
es
fr
hr
hu
it
nl
pl
ro
sl
45