Table of Contents
Advertisement
3
Install Exterior Keypad
1. Refer to measurements G and H on the Door Checker (page 6) to measure face
bore hole. If the hole is 1-1/2" (G), unscrew the two small screws and remove the
adapter.
Install your lock with the door open.
Do not close your door until all the steps are completed.
2. Make sure your deadbolt latch is in an unlocked position. Refer
to step 2, point 4 (page 13) for guidance on how to retract it, if
needed.
3. Slide the tailpiece through the deadbolt latch slot, making sure
the keypad is on the exterior part of your door.
4. Guide the wire cable under the deadbolt.
5. Slide the keypad in place. Hold or secure in place until the
mounting plate is installed in the next step.
P/N YRD604-KD-BLE-0047 Rev A
1
5
3
4
14
2
Advertisement
Table of Contents
