Table of Contents
Advertisement
Figure2-28 Installing a power module
Removing a power module
CAUTION:
When the switch has power modules in 1+1 redundancy mode, removing one power module does
not affect the operation of the switch. When the switch has only one power module installed,
removing the power module powers off the switch.
To remove a power module:
1.
Remove the power cord from the power module.
2.
As shown in Figure2-29, hold the handle on the power module with one hand, pivot the latch on
the power module to the left with your thumb, and pull the power module part way out of the slot.
Supporting the power module bottom with the other hand, slowly pull the power module out of
the slot.
Figure2-29 Removing a power module
(1) Pivot the latch to the left with your thumb
3.
Put the removed power module in an antistatic bag for future use.
4.
If you are not to install a new power module, install a filler panel in the slot to ensure good
ventilation in the switch, as shown in Figure2-30.
(2) Pull the power module out
2-17
Advertisement
Table of Contents
