Table of Contents
Advertisement
Samsung Controller
Overview of the Samsung
Controller Initial Start Up
Location
Operation status display -
Displays the operation/function
1
settings and statuses.
Operation On/Off button
(LED display) -
2
Water Heat Pump power On /
Off
Up/Down button -
between items vertically or
3
changes the set temperature.
Left/Right button -
between items horizontally or
4
changes the item value.
OK button -
5
settings.
Save & Return button -
your new settings and returns to
6
the previous step.
Option button -
7
detailed setting function.
86
Function
Turns the Air to
Moves
Moves
Saves your new
Saves
Selects the
Initial Start Up
Please refer to controller symbols and button
functions on pages shown on the left for further
guidance on the heat pump controls.
1.
Ensure that both the outdoor and indoor
units are correctly wired and plumbed prior
to turning on.
2.
Flush the system at 110% of system flow rate
in both directions.
3.
Once the system has been power flushed
you must now fill the system with Glycol.
4.
The Glycol should be pre mixed before
putting it into the system and a solar filling
station is ideal for filling the system, use the
connections on the fill/flush and flow meter
to add the glycol.
5.
Do not put Neat Glycol into the system,
failure to do this may cause the glycol to
block the heat exchanger or block the pipes
within the heat emitter circuit.
6.
Run the solar filling station for at least an
hour to purge all the air from the system.
7.
Turn on power to the indoor unit first. Then
turn on power to the outdoor unit second.
8.
The outdoor unit will start flashing. It flashes
'scanning' while connecting the indoor and
outdoor units.
9.
Once scanning disappears from the screen
the system is ready for testing.
Advertisement
Table of Contents
