Smeg CWG420D Manual page 25

When the door is closed again, the system offers the last program run.
‐ CW 420/430
Wait for P1 to appear and LED L1 to change from red to
green; the tank heating element light comes on until the
set temperature is reached. The duration of this stage may
vary depending on the mains water temperature and on
the single‐phase connection.
Press the
boiler (right) temperatures for a short time.
Load the dishes
Select the program required by pressing .
Confirm the program start by pressing
down for 1 second (light L2 changes from green to
orange).
Cycle in progress, the progress of the cycle is displayed by
vertical bars which illuminate in sequence. If the door is
opened "CLOSE" flashes and the program stops; when it is
closed again the program restarts from the beginning.
At the end of the program "End" flashes
Unload the dishes
25
button quickly to display the tank (left) and
and holding it