Set‐up
During first start‐up, the functions/parameters listed below must be set or adjusted:
6.1 Dishwasher parameter modification procedure:
Only accessible after filling is complete or with the door open.
Indicator lights showing: off; green; orange;
Access "programming mode" by pressing the button for
a few seconds with the appliance on with the door open
and the tank empty (after the filling and heating phases).
The display shows UnLo 1:58; when the beep sounds,
release the button and press it again at once. Keep
pressing the button again to scroll through all the
modifiable parameters in the following order:
Rinsing temperature (boiler temperature)
Washing temperature (tank temperature)
Quantity of detergent dispensed (if featured), the number
indicates the seconds of peristaltic pump operation)
6 SET-UP
‐ CW 420/430
flashing.
15