Table of Contents
Advertisement
When the door is closed again, the last program is repeated.
8.4 Program change
N.B.:
During heating of the water in the boiler, the tank heating element
may appear on the display.
Filter presence sensor (on some models only)
The filter is fitted with a sensor which checks that it is properly fitted; if it is not in the correct position, the word
"FiLter" appears on the display.
PROGRAM
Glasses
P1
Glasses, cups and plates with light dirt
P2
Very dirty dishes and cutlery
P3
Depending on the duration set.
P4
(*)
The cycle duration stated above refers to three-phase appliances supplied with hot water at 50°C.
If the appliance is supplied with cold water, the cycle duration might increase depending on the intake
water temperature, since the dishwasher is fitted with the HTR system, which requires set temperature and
pressure for rinsing.
9 CHOOSING THE PROGRAM
TYPE OF DIRT
Cycle in progress, the time left until the end of the cycle
is displayed. If the door is opened "CLOSE" flashes and
the program stops; when it is closed again the program
restarts from the beginning.
At the end of the program "End" flashes
Unload the dishes
With the door closed, to change to a fresh program
instead of repeating the last one, press the
The programs available are displayed (light L2 changes
from orange to green).
If a program has already started, hold
interrupt it.
change the program by pressing
Confirm the program start by pressing
down for 1 second (light L2 changes back to orange).
and boiler heating element
Short, about 1' 30"
1' with glassware function active.
Average, about 2' 30"
2' with glassware function active.
Long, about 4'
5'30" with sani function active.
As required from 5 to 20'.
15
button.
down to
.
and holding it
symbols
DURATION (*)
Advertisement
Table of Contents
