First Start-Up; Preparing For Use - Smeg CW501D Manual

FIRST START-UP

The electrical protection system must undergo a functional test before the appliance is put into operation.
The appliance must be installed and/or inspected by the qualified staff, who will start it up for the first time and
provide the relevant operating instructions.

PREPARING FOR USE

Important:
The rinse aid dispenser is fitted on all models, the detergent dispenser only on some.
If both dispensers are present put the external detergent and rinse aid containers in
place and insert the respective intake hoses on the rear of the machine into them.
Red hose: detergent
blue hose: rinse aid
Before inserting the hoses into the containers, fit the weights (needed to ensure that
they always draw in liquid from the bottoms of the containers) and the filters onto their
ends as shown.
If the detergent dispenser is not factory-fitted, it can be by ordering the relative kit.
As an alternative an external dispenser can be fitted, making the electrical connection by means of an H05 RN-
F 2x0.5 mm electrical cable, which can be laid along the route shown in the TECHNICAL DATA diagram and
connected as shown in the wiring diagram supplied with the dishwasher.
The dispenser must operate on 230V/50 Hz with maximum power absorption of 15 W.
Connect to the detergent dispenser outside the dishwasher using the red hose mentioned above.
Whenever the type of detergent or rinse aid is changed, it is ABSOLUTELY ESSENTIAL to flush out the
peristaltic pumps by placing the external intake pipes in water for a few cycles.
Always use only products specifically recommended for use in a dishwasher.
The internal pipes of the detergent and rinse paid pumps should be replaced by the After-Sales Service
every 12 months or 15,000 wash cycles.
Failure to comply with this recommendation leads to forfeiture of the warranty entitlement on the
appliance's water system.
SETTINGS
During start-up, the functions/parameters listed below must be set or adjusted:
On first installation, a series of operations can be performed to allow the dishwasher to be customised to the user's
needs. A short testing cycle can also be performed to verify operation of all the components. To perform these
operations, access "programming mode" as explained below
5 START-UP
IMPORTANT:
6 SETTINGS
7