Installation And Positioning - Smeg CW501D Manual

INSTALLATION and POSITIONING

Bring the dishwasher to the installation site, remove the packaging and check the appliance and components
for damage; any damage found must be reported to the transporter in writing.
The packaging components (plastic bags, expanded polystyrene, nails, etc.) must not be left within reach of
children and pets since they are potentially dangerous.
All packaging materials used are environment-friendly. They can be kept without constituting any hazard, or
may be disposed of at a specialist waste disposal centre.
The plastic components suitable for recycling are marked as follows:
PE polyethylene: external packaging film, bag containing the instructions, protective bags.
PP polypropylene: straps.
PS expanded polystyrene: corner guards, top of packaging.
Wooden and cardboard components can be disposed of in accordance with the relevant regulations.
When the product is decommissioned it must not be dumped in the environment; it must be disposed of in
accordance with the relevant regulations. All metal parts are in stainless steel and can be removed.
The plastic parts are marked with the symbol identifying the material used.
POSITIONING:
Caution: the indoor system and premises in which equipment for institutions is installed must
comply with the relevant regulations.
The manufacturer declines all liability for direct or indirect injury or damage deriving from failure to comply
with these regulations.
Before installation, check that there are no objects or materials in the vicinity which may be damaged by
steam or splashes of washing solution, or that any such items are suitably protected.
Place the dishwasher in the chosen point and remove the protective film.
Level the dishwasher (with the aid of a spirit level) on its adjustable feet to ensure that it is stable; all other
mounting solutions must be approved by the manufacturer.
4 INSTALLATION INSTRUCTIONS FOR THE AFTER-SALES SERVICE
4.1 Water connection
Water supply and drain connection:
The water pipelines and electricity supply cable lead out of the bottom
right-hand corner of the appliance. Connect the water intake hose to a
connector with ¾" gas threaded fitting, fitting the filter A provided.
The connection to the water mains must only be made with new hoses; the
use of old or worn hoses is not permitted.
FOR MODELS WITH WATER SOFTENER:
An `approved` double check valve or some other no less effective
device providing backflow prevention protection to at least fluid
category three shall be fitted at the point of connection between the
water supply and the fitting or appliance.
FOR MODELS WITHOUT WATER SOFTENER:
An `approved` single check valve or some other no less effective
device providing backflow prevention protection to at least fluid
category two shall be fitted at the point of connection between the
water supply and the fitting or appliance.
3 Installation and positioning
4