Table of Contents
Advertisement
9.3 Program change
If a programme is already running, it can be changed by first switching the appliance to pause status (by
pressing one of the
10 CHOSING THE PROGRAM
When you scroll through the available programs, the program number (P1, P2, .... etc.) and its duration are
shown first, alternating with the wash and rinse temperatures.
SYMBOL
(*) The cycle duration stated above is guaranteed if the water intake temperature is as stated and
recommended in the "TECHNICAL DATA" table, and in all cases refers to the first cycle performed. For
repeated cycles, operating conditions may vary from installation to installation. If the dishwasher is
supplied with cold water, the cycle duration might increase depending on the intake water temperature
and the "thermostop" setting.
If the door is opened when a program is in progress, the program is interrupted; when the
door is closed again the program must be restarted.
Power failure.
If the door is open when power is restored, the display reads "CLOSE" and "°t" flashes; the
heating element stays off for the user's safety, in order to avoid the risk of burns.
Close the door to resume heating the water in the tank.
buttons for 2") and then selecting the programme required.
PROGRAM
Short
Medium
Long
With program started, press
interrupt it.
Change the program by pressing
TYPE OF DIRT
Glasses and cups
Glasses, cups and plates with
light dirt
Very dirty dishes and cutlery
25
and hold it down to
DURATION
(*)
1 min 30 s
2 min 30 s
4 min
Advertisement
Table of Contents
