Table of Contents
Advertisement
6.1 Dishwasher parameter modification procedure:
(ONLY ACCESSIBLE AFTER FILLING IS COMPLETE or WITH THE DOOR OPEN)
Indicator lights as follows:
Access "programming mode" by pressing the
seconds (UnLo 1:58 will appear on the display) with the appliance on (after the
filling and heating phase); at the "beep", release the button and press it
again quickly within 0.5 seconds. Keep pressing the button again to scroll
through all the modifiable parameters in the following order:
Rinse aid delivery amount
Detergent delivery amount
Rinsing temperature
Washing temperature
Start-on/start-off.
Set at "on" to start the cycle when the door is closed.
Set at "off" for cycle start after confirmation with the start button
Regeneration frequency, depending on water hardness (if softener is installed)
tStP on/off
"on" = minimum rinsing temperature as set, regardless of intake water
temperature; the cycle duration may be a few seconds longer than the nominal
length.
"off" = the minimum rinsing temperature might be a few degrees lower than
the setting if hot intake water is not used.
Rinse aid pump operating minutes display.
Detergent pump operating minutes display.
off;
green;
orange;
flashing.
on/off button for a few
8
Advertisement
Table of Contents
