Installation; Location; Installing The Camera; Remove The Camera From Sliding Bracket - Uniden DASH VIEW 60+ Owner's Manual

Dash cam vehicle recorder
Hide thumbs Also See for DASH VIEW 60+:
Table of Contents

Advertisement

Installation

Location

To have a better view, try to install the camera at the center of the windshield.
Make sure the lens is located in a place where the windshield is clean to
ensure the view is clear.
Make sure the device is not installed in a place where it will interfere with the
airbag. Make sure the GPS will not be obstructed by the windshield's sun
control film (window tint).

Installing the Camera

1. The sticker mount bracket comes pre-installed with the camera. Otherwise,
slot the sticker mount bracket into the device bracket slot and make sure
it fits tightly.
2. Clean the area you desire to have the dash cam placed before sticking the
device.
3. Peel off the 3M sticker protective film from the mount bracket.
4. Press and apply force on the mount onto the windshield behind the rear-
view mirror.
5. Arrange and hide the cables to avoid obstruction for the driver's view.
6. Adjust the viewing angle of the camera by rotating the body of the camera.
We recommend the camera should point slightly downwards ~10° below
eye level.
Do not install the product in a location where it can obstruct
the driver's field of vision.
NOTE

Remove the Camera from Sliding Bracket

To remove the camera from windscreen. Hold the camera firmly, slide it
harder horizontally to the left in
The camera can slide out of the bracket.
UNIDEN DASH VIEW 60+/60R
OPEN direction.
7
Vehicle Recorder

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dash view 60r

Table of Contents