Pro Devices For Support Arm (Extendable, Round Tube) - Siemens IFP V2 UL Operating Manual

4. Insert all connection cables through the opening of the PRO device. Make sure that the
connection cables are not damaged.
5. Attach the device with 4 M4x12 screws to the base adapter from the top, torque 2.5 Nm.
Make sure that the connection cables are not crushed.
6. Connect all cables, follow the instructions in section "Connecting the device (Page 31)".
7. Fasten the backplane cover to the device with the 8 screws, torque 1.5 Nm. Ensure that the
seal is sitting correctly.
3.3.3

PRO devices for support arm (extendable, round tube)

Requirement
• One of the following support arm systems:
– Support arm with round tube end with outside diameter 48.3 mm, appropriate for the
– Support arm with mechanical interface, appropriate for the flange of the flange mount
– Support arm with mechanical VESA interface, the corresponding Siemens adapter set
• The PRO device, all packaging components and protective films have been removed
• The lower cover of the PRO device from the accessory kit
• Torque screwdriver with T20 insert
• The following cables are fed through the support arm to which the device is mounted:
– Equipotential bonding cable
– Power supply cables
– Data cables, e.g. USB, DisplayPort or Ethernet cable
IFP V2 UL hazardous information
Operating Manual, 11/2023
opening of the PRO device
When selecting the round tube, ensure that its inside diameter is large enough so that
all needed cables and their connectors can fit through.
adapter, and Siemens flange mount adapter (not included in product package)
and the Siemens flange mount adapter (not included in product package)
Installing and connecting the device
3.3 Mounting the PRO device
27