Installing and connecting the device
3.2 Installing the built-in device
3.2.3
Fastening the built-in device using mounting clips
Requirement
• All packaging components and protective films have been removed from the device.
• The mounting clips included in the accessory kit are at hand.
• Torque screwdriver with slit insert size 2
Procedure
Note
If the mounting seal is damaged, the degree of protection is not guaranteed.
1. Insert the device into the mounting cutout from the front.
2. Make sure that all four spring locks on the top and bottom of the device fully engage. If
necessary, gently press the device into the recess if it is not fully engaged.
22
IFP V2 UL hazardous information
Operating Manual, 11/2023