Siemens IFP V2 UL Operating Manual page 24

Installing and connecting the device
3.3 Mounting the PRO device
NOTICE
Degree of protection for overall device
If you are using a support arm system or a pedestal system that does not have IP65 degree
of protection or Enclosure Type 4X/12 (indoor use only), IP65 degree of protection or
Enclosure Type 4X/12 (indoor use only) are lost for the entire device. Spray and water jets as
well as penetrating substances can then damage the device.
Use a suitable support arm system or pedestal system with IP65 degree of protection or
Enclosure Type 4X/12 (indoor use only) for your application.
Note
Liability disclaimer
The device is mounted to a pedestal or a support arm via the mechanical interface with
screws. Siemens AG assumes no liability for the consequences of incorrect installation.
Warranty at risk
If you do not install the HMI device in accordance with the specifications in these operating
instructions, the warranty for the device is voided.
• Always install the device according to these operating instructions.
• If the seal on the backplane cover is damaged, it can be repaired.
IP65 degree of protection and Enclosure Type 4X/12 (indoor use only) at risk
If there are no seals on the mechanical interfaces or if they are damaged, IP65 degree of
protection and Enclosure Type 4X/12 (indoor use only) is at risk. Check the condition and
proper seating of the seals.
NOTICE
Damaging the seal when opening
If the device has not been opened for a long time, the backplane cover or terminal
compartment cover may stick to the seal of the enclosure. Opening the device with
excessive force or with tools will destroy the seal. Spray and water jets as well as
penetrating substances can then damage the device.
Open the terminal compartment cover gently, without too much pressure.
24
IFP V2 UL hazardous information
Operating Manual, 11/2023