Siemens IFP V2 UL Operating Manual page 26

Installing and connecting the device
3.3 Mounting the PRO device
Procedure
This section describes the mounting of the device to a support arm system using example
figures. Installation on a pedestal is carried out in the same way. With PRO devices for support
arm (not extendable, flange top), the base adapter is screwed to the device from the top.
With PRO devices for pedestal (extendable, flange bottom), the base adapter is screwed to
the device from the bottom. A device for a support arm system cannot be used on a pedestal,
and vice versa.
1. If an adapter plate for the Siemens base adapter is included in your support arm system,
attach the adapter plate to the support arm with 4 M6x12 screws. Observe the torque that is
specified for the support arm.
2. Attach the base adapter with 4 M6x12 screws to the mechanical interface of the support
arm from below. Observe the torque that is specified for the support arm.
3. Loosen the 8 screws of the backplane cover and remove the backplane cover.
26
IFP V2 UL hazardous information
Operating Manual, 11/2023