Mounting The Transceiver Unit - Siemens IFP V2 UL Operating Manual

Installing and connecting the device

3.4 Mounting the Transceiver Unit

3.4 Mounting the Transceiver Unit
Note
Important notes for installation
• The device is approved for operation in closed rooms only.
• For installation in a cabinet, observe the manual "Installing control systems interference-
proof (https://support.industry.siemens.com/cs/ww/en/view/59193566)" as well as the
relevant DIN/VDE provisions and the applicable country-specific regulations.
Requirement
• The mounting rail is fastened to the side or rear of the Transceiver Unit according to the
desired mounting position.
Mounting onto standard rail
The following procedure describes an example of mounting a Transceiver Unit with a
mounting rail attached at the side on a standard mounting rail. The mounting of a
Transceiver Unit with a mounting rail attached at the rear is carried out in the same way.
Proceed as follows:
1. Place the device with the mounting rail clip from below onto the standard mounting rail.
Make sure that the unit does not tilt.
2. Push the device upward.
3. Push the device towards the standard mounting rail until the standard mounting rail clip
engages completely at the top.
30
IFP V2 UL hazardous information
Operating Manual, 11/2023