Electrolux 6 Series Service Manual page 45


Diagnostics
The diagnostics process is designed to check all the components in the tumble dryer.
To enter diagnostics mode, proceed as follows:
Turn on the tumble dryer at the On/Off button.
Wait for the LEDs to be lit and for the buzzer to
BEEP (if the alarm is not disabled).
Series 7 uses a Hi-Fi selector dial so the first
position is already selected by default.
Press the Start/Pause and Delay Start buttons
simultaneously.
WARNING
This must be done within 5 seconds after the
tumble dryer has been turned on!

Quitting diagnostics mode
To quit diagnostics mode, turn the tumble dryer off at the On/Off button, then turn it back on in order to
reset it. The display shows

Selector dial positions in diagnostics
See the paragraph which applies to all stylings "SELECTOR DIAL POSITION IN DIAGNOSTICS".
Technical Support - A.D.L.
then turn it back off.
45/76 599 74 12-74 Rev.01