Panasonic CF-62 Service Manual page 58

CF-62
@ Printer BIOS error status
0: Busy
1: Acknowiedge
1: Paper end
1: Printer is selected
1: V/O error
1: Time-out
@ When an error occurs during format, verify, write and read tests for FDD, an error message is displayed in the following format of '
the command and error names:
,
(Format of Error Message)
[Command Name] failed: [Error Name] Cylinder = xx Head = xx Sector = xx
Command Name: Read Error Name: HDC not found (FFH)
Write Bad err register (EOH)
Verify Write fault (CCH)
Format Undefined error (BBH)
Read long Drive not ready (AAH)
Write long Time-out (80H)
Command Seek error (40H)
FDC or HDC error (20H)
Data corrected (11H)
CRC or ECC error (10H)
Bad track (OBH)
Bad sector mark (OAH)
64 K boundary (09H)
DMA overrun (08H)
Parameter error (07H)
Reset error (05H)
No record (04H)
Write protected (03H)
No address mark (02H)
Invalid command (01H)
When there is a difference between write data and read data, the following error message is displayed:
Compare error Cylinder = xx Head = xx Sector = xx
@ When an error occurs during format, write long, read long, write and read tests for HDD, an error message is displayed in the
following format of command and error names:
(Format of Error Message)
[Command Name] failed: [Error Name] Cylinder = xx Head = xx Sector = xx
Command Name: Please refer to the FDD section above.
Error Name: Please refer to the FDD section above.