Panasonic CF-62 Service Manual page 28

No
mi PC CARD DIAGNOSIS
Make sure that connecting cables, connectors and AC adapter are
No. Symptom Troubleshooting procedures Source of problem | Ref.Page
No. | | Result |
1 |Cannot insert PC CARD.
¥ Cannot remove PC
is the PC CARD deformed? =
= a Slot
| 73 |
CARD. Le
: YES |Go to No. 2-2.
E 2
properly. Is a correct driver used? Diner canware |
2 Is there a conflict in YES |Configuration
configuration? (I/O Address, IRQ) | NO |Go to No. 2-3
mi STATUS LCD DIAGNOSIS
Make sure that connecting cables, connectors and AC adapter are
No. Symptom Troubleshooting procedures Source of problem | Ref.Page
No. | | Result |
; Indicator is not displayed Replace the STATUS LCD. STATUS LCD.
4-1 ' Main P.C.B. or LCD 7-10,7-12
properly. Does operation return to normal? EPC
Make sure that connecting cables, connectors and AC adapter are
not loose or disconnected prior to testing.
Data cannot be sent or 4-1 Is the Infrared Communication YES |Go to No. 1-2. | ——— |
received. Port enabled in Setup? | NO {Improper setting. ==
Is the same transmission protocol yes |
1-2 |set for both the sending and SES = < aa
receiving units? asa pier g.
CF-62 |
not loose or disconnected prior to testing.
7-3
7-9
2 |PC CARD does not work
2-3 Does Diagnostic Test report YES |Main P.C.B. 7-10
problem in PC CARD controller? | NO |PC CARD 7-3
not loose or disconnected prior to testing.
MZ INFRARED COMMUNICATION PORT DIAGNOSIS
Troubleshooting procedures Source of problem | Ref.Page
No. | | Result |
4-3 Does Diagnostic Test report YES |Main P.C.B
problem? NO {Power P.C.B