Table of Contents
Advertisement
WARNING: The microSD card must only be removed using the spring loaded "push-pull" mechanism on the microSD
socket. Improper forceful removal of the microSD card will result in permanent damage to the socket that is not
covered under warranty. To insert the card, just push it into the socket until a "click" sound is heard.
Start with the microSD card in this position relative to
the microSD slot with the text and "lip" facing up.
Use your figure to gently push the card into the socket
until it clicks.
To remove the microSD card, press the card back into the socket until another "click" sound is heard, then release
pressure on the card. At this point, the card should be partially ejected from the socket. Finally grab the card and
gently pull to remove it. See the following pictures for proper micro-SD removal:
To remove the microSD card, gently push it into the
socket again until it "clicks", and then release your figure.
3/27/2024
µ E Z G U I U s e r ' s M a n u a l
Pin Number
1
2
3
4
5
6
7
8
9
10
11
12
Next gently insert the card partially into the socket.
At this point the microSD card is fully inserted. It should not
fall out, even if the unit is shaken vigorously.
At this point, the microSD card should partially stick out
of the socket.
Copyright ©2024, Future Designs, Inc.
Description
Micro SD DAT2
Micro SD DAT3
Micro SD CMD
3.3V
Micro SD SCLK
Ground
Micro SD DAT0
Micro SD DAT1
Micro SD CD
Micro SD CD
Ground
Ground
P a g e
| 19
Revision 1.4
Advertisement
Table of Contents
