Table of Contents
Advertisement
Sleeve Installation
To install or replace a sanding sleeve:
DISCONNECT MACHINE FROM POWER!
1.
Remove the lock knob, drum washer, sand-
2.
ing sleeve, sanding drum and table insert.
Clean the table insert and spindle areas as
3.
necessary.
Replace the table insert.
4.
Referencing the table on Page 16, install
5.
the table insert that corresponds to your
desired sanding drum.
Install the desired sanding drum on the
6.
spindle shaft, then install the correspond-
ing sanding sleeve on the drum, referencing
Page 16, as is shown in Figure 10.
Sanding
Drum
Table
Insert
Spindle
Figure 10. Sleeve installation order.
Secure the sanding drum with the appropri-
7.
ate drum washer and lock knob, then lock
until the rubber sanding drum places slight
pressure on the sanding sleeve. DO NOT
overtighten the lock knob.
Model G0723 (Mfd. Since 03/24)
To sand a workpiece:
1.
2.
3.
Lock Knob
Spindle
Washer
Sanding
Sleeve
Sanding
Ensure that the lock knob is secured tightly
and that the work area is free of obstructions
and obstacles.
Turn the spindle sander ON and allow it to
reach full speed.
Using both hands, guide the workpiece
against the sanding sleeve in a right-to-left
manner, as shown in Figure 11. DO NOT
force the workpiece against the sanding
sleeve.
Sanding Direction
Figure 11. Sanding workpiece.
Spindle
Rotation
-17-
Advertisement
Table of Contents
