Sanding Sleeve - Grizzly G9922 Owner's Manual

hold the workpiece flat on the table and
6.
against the miter gauge, and begin sliding
the gauge back and forth in the slot on the
table. at the same time, gradually move the
workpiece into the sanding drum (figure
28).
figure 28. Workpiece placement.
Continue sliding the miter gauge back and
7.
forth while applying slight pressure against
the sanding drum. once sanding is complete,
slide the miter gauge away from the drum,
and turn the sander OFF.
-24-

Sanding Sleeve

the sanding sleeves on the Model g9922 can be
replaced when they become worn or damaged.
To replace sanding sleeves:
disConnECt sandEr FroM poWEr!
1.
use a 19mm wrench on the sanding drum
2.
base nut to keep the spindle from turning
(figure 29).
sanding drum
sanding drum Base nut
figure 29. securing spindle.
remove the plastic cap from the sanding
3.
drum. it has left-hand threads and unscrews
clockwise (figure 30).
plastic Cap
figure 30. loosening nut.
loosen the hex nut until the sanding sleeve
4.
can slide off the drum. the hex nut has left-
hand threads and unscrews clockwise.
slide the new sleeve over the drum, then
5.
tighten the hex nut and replace the plastic
cap.
hex nut
g9922 (mfg. since 12/01)