Table of Contents
Advertisement
(Cont'd from page 24 )
2. Install the port retainer set into the groove in the machined end of the feed/concentrate port.
Pull port back until retaining ring set bottoms in bearing plate recess.
STEP 3 INSTALL SEALING PLATE
1. Hold these components together so that the retaining ring set remains firmly seated. With its
larger diameter facing the bearing plate, press the sealing plate onto the machined end of
the feed/concentrate port.
2. Rotate sealing plate until the two center holes are aligned.
STEP 4 INSTALL PERMEATE PORT
1. From sealing plate side, insert threaded end of permeate port through bearing/sealing plate
combination. Press firmly until permeate port bottoms on sealing plate.
2. Thread port nut (left-hand thread) onto permeate port. Tighten until snug.
80E45/60, 80E100/120 ONLY
Installing port retaining set
Installing permeate Port
NOTE
Head assembling of the 80E45/60 and
80E100/120 is now complete.
Page 26 of 38
Advertisement
Table of Contents
