Vga Module - Dell OptiPlex Small Form Factor 7020 Owner's Manual

VGA module

Removing the VGA module
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 3.5-inch hard
5. Remove the disk-drive
6. Remove the processor fan and heat-sink
About this task
The following image indicates the location of the VGA module and provides a visual representation of the removal procedure.
Figure 50. Removing the VGA module
Steps
1. Remove the two screws (M3) that secure the VGA module to the chassis.
2. Disconnect the VGA-module cable from its connector (VIDEO) on the system board.
3. Lift the VGA module off the system board.
Installing the VGA module
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Before working inside your
drive, if applicable.
cage.
assembly.
computer.
Removing and installing Field Replaceable Units (FRUs)
Restricted - Confidential
97