Dell OptiPlex Small Form Factor 7020 Owner's Manual page 102

About this task
The following image indicates the location of the HDMI module and provides a visual representation of the installation procedure.
Figure 55. Installing the HDMI module
Steps
1. Using a screwdriver, remove the HDMI module cover from the chassis.
NOTE: This step is applicable only when the HDMI module is being installed for the first time.
NOTE: To remove the optional-module cover, insert a flat-head screwdriver in the hole of the cover, push the cover to
release it, and then lift the cover off the chassis .
2. Connect the HDMI-module cable to its connector (VIDEO) on the system board.
3. Insert the HDMI module into the slot on the chassis.
4. Replace the two screws (M3x3) that secure the HDMI module to the chassis.
Next steps
1. Install the processor fan and heat-sink
2. Install the disk-drive cage.
3. Install the 3.5-inch hard
4. Install the front bezel.
5. Install the side cover.
6. Follow the procedure in
102 Removing and installing Field Replaceable Units (FRUs)
assembly.
drive, if applicable.
After working inside your computer.
Restricted - Confidential