Installing The Power Button - Dell OptiPlex Small Form Factor 7020 Owner's Manual

Restricted - Confidential
Figure 35. Removing the power button
Steps
1. Disconnect the power button cable from its connector (PWR SW) on the system board.
2. Press the release tabs on the power-button head and push the power-button head outside the chassis.
3. Slide the power-button cable out from the front-side of the chassis of the computer and remove the power-button from the
computer.

Installing the power button

CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power button and provides a visual representation of the installation
procedure.
78 Removing and installing Field Replaceable Units (FRUs)