Dell OptiPlex Small Form Factor 7020 Owner's Manual page 64

Restricted - Confidential
Figure 23. Removing M.2 2280 solid-state drive from Dell Ultra Speed Drive Gen3 card
Steps
1. Pull the tab to open the PCIe door.
2. Press down on the release tab on the PCIe slot (SLOT 2) and lift the Dell Ultra Speed Drive Gen3 card off the system board.
3. Turn the Dell Ultra Speed Drive Gen3 card over.
4. Remove the screw (M2x5) that secures the M.2 2230 or 2280 solid-state drive to the Dell Ultra Speed Drive Gen3 card.
5. Turn the Dell Ultra Speed Drive Gen3 card over.
6. Remove the M.2 solid-state drive standoff nut from the M.2 2230 or 2280 solid-state drive.
7. Slide the M.2 2230 or 2280 solid state drive out of the M.2 2230 or 2280 slot on the Dell Ultra Speed Drive Gen3 card.
Installing the Dell Ultra Speed Drive Gen3 card
About this task
NOTE: The Dell Ultra Speed Drive Gen3 card must be installed in the PCIe x16 slot (SLOT 2).
The following images indicate the location of the Dell Ultra Speed Drive Gen3 card and provide a visual representation of the
installation procedure.
64 Removing and installing Customer Replaceable Units (CRUs)