HDMI module
Removing the HDMI module
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
3.5-inch hard
5. Remove the
disk-drive
6. Remove the
processor fan and heat-sink
About this task
The following image indicates the location of the HDMI module and provides a visual representation of the removal procedure.
Figure 54. Removing the HDMI module
Steps
1. Remove the two screws (M3x3) that secure the HDMI module to the chassis.
2. Disconnect the HDMI-module cable from its connector (VIDEO) on the system board.
3. Lift the HDMI module off the system board.
Installing the HDMI module
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Before working inside your
drive, if applicable.
cage.
assembly.
computer.
Removing and installing Field Replaceable Units (FRUs)
Restricted - Confidential
101
Need help?
Do you have a question about the OptiPlex Small Form Factor 7020 and is the answer not in the manual?
Questions and answers