Intrusion Switch; Removing The Intrusion Switch - Dell OptiPlex Small Form Factor 7020 Owner's Manual

Figure 32. Installing the speaker
Steps
1. Press the tab on the speaker and slide the speaker into the slot on the chassis until it snaps into place.
2. Connect the speaker cable to its connector (INT SPKR) on the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in

Intrusion switch

Removing the intrusion switch

CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
The following image indicates the location of the intrusion switch and provides a visual representation of the removal procedure.
74 Removing and installing Customer Replaceable Units (CRUs)
After working inside your
Before working inside your
computer.
computer.
Restricted - Confidential