Installing The Disk-Drive Cage - Dell OptiPlex Small Form Factor 7020 Owner's Manual

Restricted - Confidential
Steps
1. If the optical drive is installed, remove the data and power cables from the routing points on the disk-drive cage.
2. Remove the screw (#6-32) that secure the disk-drive cage to the chassis.
3. Lift the disk-drive to a certain angle and slide it outwards to detach it from the mounting points on the chassis.
4. Rotate the drive-cage upside down and place it on the chassis.
5. If the optical drive is installed, disconnect the power and data cables from the connectors on the optical drive.
6. Lift the disk-drive cage away from the computer.

Installing the disk-drive cage

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the disk-drive cage and provide a visual representation of the installation
procedure.
50 Removing and installing Customer Replaceable Units (CRUs)