Processor; Removing The Processor - Dell OptiPlex Small Form Factor 7020 Owner's Manual

Figure 45. Installing the processor fan and heat-sink assembly
Steps
1. Place the processor fan and heat-sink assembly on the system board and align the captive screws to the screw holes on the
system board.
2. In sequential order (1>2>3>4), tighten the four captive screws that secure the processor fan and heat stink assembly to the
system board.
3. Connect the processor-fan cable to its connector (FAN CPU) on the system board.
Next steps
1. Install the disk-drive cage.
2. Install the 3.5-inch hard
3. Install the front bezel.
4. Install the side cover.
5. Follow the procedure in

Processor

Removing the processor

CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 3.5-inch hard
5. Remove the disk-drive
6. Remove the processor fan and heat-sink
92 Removing and installing Field Replaceable Units (FRUs)
drive, if applicable.
After working inside your
Before working inside your
drive, if applicable.
cage.
assembly.
computer.
computer.
Restricted - Confidential