Table of Contents
Advertisement
USER GUIDE
General Installation
INSTALLATION
1.
Position unit in front of cutout and remove upper grille.
2.
Verify operation by plugging power cord in receptacle.
3.
Open door. Control panel should be lit. Verify the
position of the power on/off and showroom switch if
there is no power to the unit.
4.
Replace upper grille.
NOTICE
Power switch will be shipped in the "ON"
position.
5.
Roll unit into the cutout to within 3" (7.6 cm) of being
flush with cabinets. To avoid kitchen cabinet damage,
place cardboard between cabinets and unit. Push
cardboard back with unit and remove cardboard when
unit is in place.
General Installation
LEVELING
1.
Remove lower grille (See GRILLE INSTALLATION).
2.
Lift the unit off its rollers, adjust to desired height and
level unit by using a 5/16" hex head wrench.
a) To raise/lower right side rear, rotate the right side
rear hex rod.
b) To raise/lower left side rear, rotate the left side
rear hex rod.
c) To raise/lower right side front, rotate the right side
front hex rod.
d) To raise/lower left side front, rotate the left side
front hex rod.
DETAIL "A"
LEFT SIDE
FRONT
REAR
Leveling
Legs Adjusters
Front view with
A
grille removed.
3.
Align unit with sides of cabinets by adjusting leveling
legs. Rotate leveling legs until firmly in place against
floor.
4.
To secure unit, raise unit until compartment cover is
firmly seated under the soffit or anti-tip boards.
5.
Replace lower grille.
11
DETAIL "B"
RIGHT SIDE
FRONT
REAR
Leveling
Legs Adjusters
B
Advertisement
Table of Contents
Troubleshooting
