Anti-Tip Bracket - Viking VCWD630-SG41A User Manual & Service Manual

USER GUIDE

Anti-Tip Bracket

WARNING
!
Unit is top heavy and tips easily when not
completely installed. Keep doors closed until
appliance is completely installed and secured per
installation instructions.
Use two or more people to move and install
appliance. Failure to do so can result in death or
serious injury.
OPTION 1
If a solid soffit is 1" (2.5cm) or less above the unit, anti-tip
boards are not required. To secure the unit raise it until it
is firmly seated under the soffit.
OPTION 2
If a solid soffit is not available or soffit is more than 1" (2.5
cm) above the unit, center wood boards on rear wall 1/4"
(0.6 cm) maximum above the unit. Attach wood boards to
wall studs with six of the provided wood screws, making
sure that screws are engaged in wall studs 1-1/2" (3.8 cm)
SOLID SOFFIT
1" (2.5 cm)
OPTION 1
Anti-Tip Bracket
or less
OPTION 2
Rear Wall
minimum and that boards extend 2" (5.0 cm) minimum
over the top rear of the unit's compressor cover. To secure
the unit, raise it until compartment is firmly seated under
the anti-tip board.
OPTION 3
Position the wood block over the unit and secure it to wall
studs using eight of the provided wood screws and "L"
brackets. Make sure screws extend a minimum of 1" (2.5
cm) into each of the two wall studs. The wood block must
extend a minimum of 3" (7.6 cm) over the unit. To secure
the unit, raise it until firmly seated under the anti-tip
boards.
⁄ "
(0.6 cm)
maximum
Two 2 x 4
boards
attached to
wall with six
wood screws
(minimum)
2" (5 cm)
minimum
10
⁄ "
(0.6 cm)
maximum
"L" bracket
with (4) screws
on each end.
(1) 2 x 4
attached to
both "L"
3"
(7.6 cm)
brackets -
minimum
minimum of
1" (2.5 cm) screws.
Screws extend
minimum of
1" (2.5 cm) into
OPTION 3
each wall stud.