Table of Contents
Advertisement
USER GUIDE
Control Operation
CONTROL FUNCTION GUIDE
FUNCTION
COMMAND
Power on/off
Press
Press
upper zone.
Adjust Temperature
Press
Press
Toggle between 0F/0C
Hold
Press
Leave interior light on
light on for 12 hours; press again to
deactivate.
Hide display
Hold hidden button and press
While holding
Adjust light color
to scroll through options.
Press
Enable Sabbath mode
release.
Press
Disable Sabbath mode
release.
Showroom mode
Hold
Door Alert Notification
When door is left open for more than 30 minutes:
•
A tone will sound for several seconds every minute
will appear in display
•
•
Close door to silence alert and reset
High/Low Temp Notifications
When the compartment temperature exceeds the control
setting for an extended period of time:
•
"HH" will appear in display (High Temp)
•
"LL" will appear in display (Low Temp) Contact service
department for further instructions.
Control Operation
Hidden
Button
to turn unit on or off
or
and release to adjust
to change to lower zone.
or
and release to adjust.
and
for 5 seconds.
and release to leave interior
, press and release
and hold for 5 seconds and
and hold for 5 seconds and
and
for 5 seconds.
NOTES
Unit will immediately turn ON or OFF.
Interior lights indicates zone temperature being set:
Blue = Upper 380 - 650 F (3.30 - 18.30 C)
White = Lower 380 - 650 F (3.30 - 18.30 C)
Note: the set temperature of the lower zone cannot be colder
than the set temperature of the upper zone.
Adjusting the set temperature of the upper zone may cause
the lower zone to automatically adjust. The lower zone
cannot be more than 200 above the set temperature of the
upper zone.
The display will change units.
After 12 hours, factory default is restored; light will turn on
when door is open.
Display will turn off when door is closed. Unit will continue to
.
operate. Repeat command to turn on.
Option
Open Door
White
00
Blue
01
White
02
Light will be set at full intensity when door is open, and 50%
intensity when door is closed.
Interior light and display will go dark and remain so until
user resets mode - unit continues to operate.
Display and interior light return to normal operation.
The 0F/0C symbol will flash. Display will be lit and interior
light will function. UNIT WILL NOT COOL. Repeat command
to return to normal operation.
First Use
INITIAL STARTUP
Initial startup requires no adjustments. When plugged in, the unit
will begin operating under the factory default settings. If the unit
was turned off during installation, simply press
immediately switch on. To turn the unit off, press
Note: Temperature displayed reflects actual temperature inside the
unit. If the temperature displayed is different than selected, the unit
is progressing towards the selected temperature. Time to reach set
point varies based upon ambient temperature of the product loaded,
door openings, etc. It is recommended that the unit is allowed to
reach its set points before loading product.
15
Closed Door
White
Blue
Blue
and the unit will
.
Advertisement
Table of Contents
Troubleshooting
