Advertisement
WINE COOLER
Unpack;
•
Remove banding from carton. Lift carton up
and off the wine cooler.
•
Remove all tape and packaging material
from the outside and inside of the cabinet.
•
Keep all carton packaging until your wine
cooler has been thoroughly inspected and
found to be in good condition.
Locate Unit;
This unit must be installed in an area protected
from the elements, such as wind, rain, water
(spray or drip).
•
Place unit so the front side will be
completely unobstructed to provide proper
air flow.
•
Area should be well ventilated with the
temperature above 55° and 110°F.
results are obtained at temperatures between
65° and 80°.
•
Provisions
for
determined before placing unit in proper
place.
•
The unit may be closed in on the top and
three sides, but the front MUST BE
unobstructed for air circulation and proper
operation. Installation should be such that
the cabinet can be moved for servicing if
necessary.
Leg / Glide Installation;
•
Align the four (4) U-clips (nuts) with the
holes in the bottom of the frame as shown in
the assembly sequence section below. Note
the direction of the tangs on the clip. These
must be located on the bottom of the flange
as shown. Incorrect installation, with tangs
on top, will destroy the U-clip and make it
useless.
•
Screw glides into U-clips. Glides should be
screwed in until smug and then backed off to
level unit.
WARNING: The U-clips
intended for glide use only! Do not place
clips on unit without using glides as this will
scratch or damage the floor surface.
Personal injury may occur.
Best
electricity
should
be
•
After placing unit in position, check to make
certain the unit is level side to side and front
to back.
•
Accurate leveling es essential for proper
operation.
3
Advertisement
