Jimmy HW11 Pro Max Instruction Manual page 8

Handheld assembly and disassembly
Take the handheld vacuum cleaner installed with the
battery pack, first insert the dust cup suction mouth
into the groove of the mainbody cover, then press the
handheld body to the installed metal tube, after hearing
a "click", the handheld vacuum cleaner is successfully
installed. and the product is used as an upright vacuum
cleaner in this status. To remove the handheld vacuum
separately, simply press and hold the handheld release
button and lift handheld vacuum cleaner diagonally
upwards. (Fig 4)
Charge base assembly
Press charging base upper, cleaning solution housing,
and brushroll housing to the charging base lower along
the illustrated position until a "click" sound is heard. (Fig 5)
Place machine to charging base
Make sure floorhead is in upright position, hold machine
handle to lift the machine, aim charging slot on bottom
of machine to the charging socket on charging base and
put the machine into charging base. To use the machine,
hold machine handle and lift out machine from charging
base (Fig 6)
Dirty water tank assembly and disassembly
To assemble dirty water tank, place dirty water tank
bottom into mainbody, push dirty water tank towards
mainbody until a "click" sound is heard.
To take off dirty water tank, hold machine with one hand
and hold dirty water tank with another hand, press dirty
water tank release button to pull out dirty water tank. (Fig 7)
Clean water tank disassembly and assembly
To take off clean water tank, hold the clean water tank
handle and pull out the clean water tank.
To assemble clean water tank, put the clean water tank
back to nozzle, align with the brushroll window. (Fig 8)
Brushroll assembly and disassembly
To remove the brushroll assembly, remove the clean
water tank assembly as detailed in (Fig 8), hold the
floorhead down with one hand, rotate the brushroll
end cap upwards with the other hand, and remove the
brushroll outward;
When installing the brushroll assembly, first align the
other end of the brushroll with the spline, rorate the
brushroll to the end, and then push the brushroll inward,
rotate the brushroll end cover down and install it in place,
align brushroll cap with the floorhead top surface. (Fig 9)
6
Handheld
vacuum
cleaner
4
Cleaning solution
housing
5
6
Dirty water tank
7
release button
Clean water tank
8
handle
9
Handheld release
button
Charging base upper
Brushroll housing
Charging base lower
Charging slot
Spline