Jimmy HW11 Pro Max Instruction Manual page 12

cord is connected to the charging base, and the clean
water tank retains at least 1/2 of the water; After
completing the self-cleaning, clean the dirty water tank
again;
3. When the battery is less than or equal to 10% power,
the self-cleaning mode cannot be turned on, and it can
be turned on normally after charging for a period of time.
Clean water tank Water filling plug
22
Clean water tank empty indicator
1. When using the water spray function, the voice/screen shows "No clean water, fill in water", please turn off
the machine and add water to the clean water tank.
2. When using the self-cleaning mode, if it is detected that there is no water in the clean water tank, the
brushroll self cleaning will be stopped. To continue self cleaning, please add water to the clean water tank and
empty the dirty water tank, then restart self clean mode.
Fill up clean water tank
Fill up clean water tank: Remove the clean water tank and lift the water filling plug of the clean water tank or
directly open the water filling plug of the clean water tank, expose the water inlet hole, pour clean water and
cleaning solution in,, and press the water filling plug down to install it to the end, and install it back into the
clean water tank. (Fig 22)
Note: When adding clean water, you can add the equipped cleaning solution in the ratio of about one bottle
cap to one full tank of clean water.
Dirty water tank full indicator
1. When the upright vacuum cleaner detects that the dirty water tank is full, the machine will stop and give a
voice reminder. Please clean the full dirty water tank and put it back.
2. When it is detected that the dirty water tank is full in self clean mode, the machine will stop working and
give a voice reminder. Please clean the full dirty water tank and put it back.
Dirty water tank cleaning
Take out dirty water tank upper cover and filter frame, dump the dirty water, assemble the dirty water tank
after washing, and put it back on the floorhead (refer to Chapter 3 "Cleaning of dirty water tank" for details).
Brushroll stuck indicator
When the cleaner is in working or cleaning mode, if the brushroll is stuck, the machine will stop and give a
voice reminder. Please take out the brushroll, clean up the foreign matter or entangled hair on the brushroll.
Brushroll cleaning
After removing the clean water tank, pull out brushroll, use the cleaning brush to cut off and remove the hair
winded around the brushroll , and clean the foreign matter attached to the brushroll and floorhead, Install
brushroll and clean water tank back (refer to Chapter 3 "Cleaning of Floorhead assembly" for details).
Air path blocked indicator
1. When the upright cleaner is working /self cleaning mode, if the air path is blocked, the machine will stop
working and give a voice reminder. Please clean the possible blockage of the handheld dust cup, floorhead
air path and handheld HEPA, check and clean up in turn before continuing to work.
2. When handheld vacuum cleaner is working, if the air path is blocked, cleaner will automatically stop. At this
time, the dust cup and HEPA need to be cleaned.
10