Table of Contents
Advertisement
GENERAL MAINTENANCE－
PREPARATION OF YOUR UTV FOR DRIVING AFTER STORAGE
After storage, your UTV requires particular attention and adjust-
ments to make sure you will enjoy many miles of trouble-free driv-
ing. To take your UTV out of storage, KYMCO recommends using
the following procedure:
1. Clean your UTV thoroughly
2. Clean the engine. Remove the cloth from the exhaust system
outlet
3. Check all control wires and cables for signs of wear or fraying.
Replace any suspect items
4. Change the engine/transmission oil and filter
5. Charge the battery and test the voltage (refer to page 77) before
installation. When installing the battery, connect the positive cable
first．
Before installing the battery, make sure the ignition
switch is in the OFF position. Connect the positive
cable to the battery first.
6. Inspect the brake system. Verify the good condition of the brake
fluid, pads and the controls
7. Verify the proper operation and adjustment of all controls, head-
lights, taillight, brakelight adjust or replace items as necessary.
80
8. Check the tire pressures inflate the tires to the recommended
pressure
9. Tighten all nuts, bolts, cap screws, and screws tighten these
fasteners to the proper torque specification. Make sure that the
rivets holding components together are tight-replace any loose
rivets.
10. Make sure the steering moves freely and does not bind.
11. Check the spark plug clean or replace as necessary.
12. Follow the recommendations listed in the Pre-Drive Inspection.
Advertisement
Table of Contents
