Table of Contents
Advertisement
GENERAL MAINTENANCE
BRAKE PADS MUST BE BEDDED-IN TO ACHIEVE FULL
BRAKING EFFECTIVENESS.
Braking distance will be greater until brake pads are
properly bedded-in.
TO PROPERLY BED-IN THE BRAKES, USE FOLLOW-
ING PROCEDURE:
*Choose an area sufficient to safely accelerate your UTV
to 30 mph and smoothly brake to a stop
*Accelerate to 30 mph, then depress the brake pedal to
decelerate to 0 - 5 mph
*Repeat procedure five times.
Do not attempt sudden stops or put yourself into a
situation with your UTV where a sudden stop will be
required until the brake pads are properly bedded-in.
After the completion of the break-in period, your UTV's
engine oil and oil filter should be changed. Other
maintenance after break-in should include checking of all
prescribed adjustments and tightening of all fasteners. It is
your responsibility, as the owner and driver of your UTV, to
arrange for and pay for this initial service.
Because of the technical ability and resources available to an
authorized KYMCO dealer, it is best to take your UTV to the
dealer for service rather than attempting to perform this initial
service yourself.
NOTE: Proper maintenance of your UTV is important for optimum
■
performance and safety. Follow the Maintenance
Schedule listed in this manual and in other official
KYMCO publications.
If you become aware of any abnormal noises, vibrations, or im-
proper function of any component of your UTV, DO NOT OPER-
ATE THE UTV. Take your UTV to an authorized KYMCO ATV
dealer for inspection and adjustment or repair.
If you do not feel qualified to perform any of the
maintenance procedures or inspections listed in this
Owner's Manual, take your UTV to an authorized KYMCO
dealer for professional service.
NOTE: The instructions and information on the following pages
■
refer to specific items in the maintenance and care of your UTV.
65
Advertisement
Table of Contents
