KYMCO UXV450i 2023 Manual page 68

GENERAL MAINTENANCE
■ NOTE: Skip step 5 and proceed to step 7 if you are not
going to replace the oil filter cartridge.
5. Remove the oil filter cartridge
wrench. Rotate the oil filter cartridge counterclockwise
to remove it from the engine.
6. Lubricate the new oil filter cartridge's o-ring gasket with
clean engine oil and install the filter on the engine.
Tighten the oil filter cartridge by rotating it clockwise
unit it securely seats to the engine
7. Reinstall the oil strainer and its component parts.
Tighten the oil strainer cap securely
8. Reinstall the oil drain plug and tighten it securely
9. Add the appropriate amount of engine oil
OIL QUANTITY
Without oil filter .............. 0.58 U.S. Gal. (2.2 L)
With oil filter change ...... 0.63 U.S. Gal. (2.4 L)
■ NOTE: Dispose of the used oil and filter in an environ-
mentally proper way.
68
with a suitable oil filter
Any oil used in place of the KYMCO recommended
engine oil can cause serious engine damage.
10. Warm up the engine for several minutes, then turn it off
11. The oil level should be above the "L" mark but not
higher than the "H" mark. Add oil through the filler cap as
required.
■NOTE: The UTV should be parked on level ground, with
the engine off, when checking the engine oil
level. Wait approximately one minute after
running for the oil level to stabilize before
checking.
Do not overfill the engine with oil. Overfilling the engine can
cause oil leaks and/or oil contamination of the air filter
element. Always make sure the oil level is above the "L"
mark but not higher than the "H" mark.