Table of Contents
Advertisement
GENERAL MAINTENANCE－PREPARATION FOR STORAGE
Prior to storing your UTV, it should be properly
serviced
to
prevent
deterioration.
KYMCO recommends the procedures listed on this page to prepare
your UTV for storage. If you lack the technical ability to prepare your
UTV for storage, consult an authorized KYMCO dealer about
performing this service.
1. Clean the seat and head cushions (cover and base) with a damp
cloth and allow to the surfaces to dry
2. Clean your UTV thoroughly by washing dirt, oil, grass, and other
debris from the entire vehicle. Allow the UTV to dry thoroughly. DO
NOT get water into the engine, air intake or exhaust
3. Drain the gas tank completely or add a fuel stabilizer to the fuel
in the gas tank. Remove the air filter housing cover and air filter
4. Start the engine and allow it to idle, then spray KYMCO Engine
Preserver into the air filter opening for a period of ten to twenty
seconds. Turn off the engine and reinstall the air filter and housing
cover
If the interior of the air filter housing is dirty, clean it of
any debris before starting the UTV's engine.
component
rusting
and
5. Drain the gasoline from the carburetor float bowl.
6. Plug the exhaust system outlet with a clean cloth
7. Apply some light oil to the upper steering post bushing and
shafts of the shock absorbers
8. Tighten all nuts, bolts, cap screws, and screws-tighten these
fasteners to the proper torque specification. Make sure that the
rivets holding components together are tight - re place all loose
rivets
9. Disconnect the battery cables (negative cable first) and then
remove the battery. Clean the battery posts and cables. Store the
battery in a clean, dry area were you can access it for periodic
charging
10. Store your UTV indoors, parked in a level position
Do not store your UTV outside in direct sunlight to
avoid damage to the body work. Avoid using a plastic
cover as moisture can condense on the UTV, causing
rust and corrosion.
79
Advertisement
Table of Contents
