Table of Contents
Advertisement
2100F12 User Manual
5.9.10 WEB Setting
To configure the parameters of WEB, perform the following steps:
Choose System> WEB Setting.
1.
Set HTTP enable. If you set HTTP disable, you will can't login the web management page
2.
with the HTTP protocol from WAN side.
3.
Set HTTP port. If you want to change the login port, you can set a new port in the box, the
default HTTP port is 80.
4.
Set HTTPS enable. If you want to login the web management page with the HTTPS protocol
from WAN side, you need to enable the HTTPS.
5.
If you want to login the web management page form the WAN, you need to Enable
Allowing login from WAN.
6.
Set the HTTPS port.
7.
Click Submit. As shown in Figure 5-88.
62
Advertisement
Table of Contents
