Table of Contents
Advertisement
2100F12 User Manual
5.6.2.14 5.2.8.2 Configuration the DHCP Server
DHCP enables individual clients to automatically obtain TCP/IP configuration when the server
powers on. You can configure the CPE as a DHCP server or disable it. When configured as a DHCP
server, the CPE automatically provides the TCP/IP configuration for the LAN clients that support
DHCP client capabilities. If DHCP server services are disabled, you must have another DHCP server
on your LAN, or each client must be manually configured.
To configure DHCP settings, perform the following steps:
1.
Choose Network Setting > LAN Settings.
2.
Set the DHCP server to Enable.
3.
Set Start IP address.
This IP address must be different from the IP address set on the LAN Host Settings area, but
they must be on the same network segment.
4.
Set End IP address.
This IP address must be different from the IP address set on the LAN Host Settings area, but
they must be on the same network segment.
Set Lease time.
5.
Lease time can be set to 1 to 10,080 minutes. It is recommended to retain the default
value.
6.
Click Submit. As shown in Figure 5-17.
5.2.9 DMZ Settings
If the demilitarized zone (DMZ) is enabled, the packets sent from the WAN are directly sent to a
specified IP address on the LAN before being discarded by the firewall.
To set DMZ, perform the following steps:
Choose Network > DMZ Settings.
1.
Set DMZ to Enable.
2.
29
Advertisement
Table of Contents
