Table of Contents
Advertisement
2100F12 User Manual
5.
The software upgrade starts. After the upgrade, the CPE automatically restarts and runs the
new software version. As shown in Figure 4-2.
During an upgrade, do not power off the CPE or disconnect it from the
computer.
4.2 Auto upgrade
To perform a ftp auto upgrade successfully, make sure the CPE is connected to the Internet.
To perform a ftp auto upgrade, perform the following steps:
1.
Choose Update>Auto upgrade.
2.
Enable auto upgrade.
3.
If you want to check new firmware after connect to Internet, you need to enable the item of
Check new firmware after connect to Internet.
Set the ftp server address to the Upgrade folder box.
4.
5.
Set Version file. //This contain the new FW name
6.
Set User name and Password.
7.
Set the Interval of checking new firmware. //Check upgrade periodic
8.
Set Start time. // The time of upgrade begin
9.
Set Random time. // Out of this time, UE will not upgrade.
10. Click Submit. As shown in Figure 4-3.
1,The CPE will automatically upgrade according to the setting. During an upgrade,
do not disconnect the power supply or operate the CPE.
2,If set interval of checking new FW, the start time and random time will
shouldn't be set.
16
Advertisement
Table of Contents
