LawnMaster CLGT2412S Operator's Manual page 27

MAINTENANCE
10. Reinstall the spool cover by depressing tabs into slot in the trimmer head and pushing down until
spool cover clicks into place.
®
NOTE: Use LawnMaster spool model # 221043107 for replacement.
LINE REPLACEMENT
1. Remove the battery pack.
2. Remove the spool from the trimmer head. Remove any old line remaining on the spool.
NOTE:
3. Cut a piece of line approximately 9 ft. (2.7 m) long.
4. Insert the line into one of the two anchor holes found on the upper part of the spool. Wind the line
around the spool clockwise as shown by the arrows on the spool (Fig. 23).
and the outside edge of the spool.
6. Check the spool cover, spool, and spool base for wear. If necessary, replace the worn parts.
7. Install the spool in the trimmer head and replace the spool cover as described in SPOOL
REPLACEMENT section.
STORAGE
1. Remove the battery pack from the trimmer before storing.
2. Clean the product as described above.
3. Store the product and its accessories in a dry, frost-free place.
4. Always store the product in a place that is inaccessible to children. The ideal storage temperature is
between 50°F (10°C) and 86°F (30°C).
5. We recommend using the original package for storage or covering the product with a suitable cloth
to protect it against dust.
Spool Cover
Tabs
Spool
Eyelet
Anchor
Hole
Fig. 22
27
Slot
Fig. 23