LawnMaster CLGT2412S Operator's Manual page 20

OPERATION
ADVANCING THE TRIMMING LINE
The trimmer features a fully automatic single line system. The line will automatically elongate every
time you turn on the trimmer.
NOTE: Bumping the head to try to advance the line will damage the trimmer and void the warranty.
off switch until the line reaches the length of the trimming line cut-off blade.
3. Resume trimming.
Adjusting the line length manually:
1. Switch off the trimmer and remove the battery.
2. Push the advance button located on the trimmer head while pulling on trimming line to manually
advance the line. The line will advance and stop. Push the button again to advance more line
(Fig. 11).
3. Push the button and pull the line out as many times as it takes to reach the line cut-off blade.
When no line end is visible:
Replace the line spool (see Spool Replacement instructions in the Maintenance section).
DEBRIS GUARD
1. The debris guard protects the operator against thrown objects during operation.
PIVOTING HEAD
1. To pivot the head, push the pivot button and adjust the shaft to any of the 7 positions (Fig. 12).
2. Adjust the angle of the trimmer head according to the intended operation (Fig. 13).
NOTE:
edges and walls.
3. Release the button, make sure the shaft locks into place.
Advance
Button
Fig. 11
20
Pivot Button
Fig. 12