Fitting The Unit Door - V-ZUG Komfort 60i Installation Instructions Manual

u Place the foam pad in the plinth panel – this is essential
for separating air flows!
Fig. 21
u Fit the plinth panel (2) without securing.
u Position the unit door and the unit plinth panel for
testing.
u If plinth panel (2) is visible, pull it forward until the front
edge of the ventilation grid and the unit plinth panel are
in line.
-or-
u If the plinth panel (2) is hidden, push it right back.
u Ensure that the ventilation slots are completely free: If
necessary, cut some off the height of the unit plinth
panel (U).
w Adjust the bar height (V) under the plinth panel (2) along
the recess width (W).
Fig. 22
u Fit and secure the plinth panel: Hold the plinth panel and
insert the catch.
u Fix the unit plinth panel.
To secure appliance in the recess:
* Depending on model and options
Fig. 20
Fig. 23
u If affixing the unit under a worktop, use 2 screws to
secure the fixing bracket under the worktop.
Fig. 24
u If attaching the unit at the side, screw the fixing bracket
into the recess with one screw on each side.

9.2 Fitting the unit door

u Fit the handle on the unit door.
u Check 8 mm presetting. (Distance between appliance
door and lower edge of crosspiece)
u Push up assembly aids Fig. 25 (12) to unit door height.
Lower edge ▲of the assembly aid = top edge of the unit
door to be fitted.
u Unscrew fastening crosspiece Fig. 25 (11) by undoing the
locknuts Fig. 25 (10).
Installation
Fig. 25
39